Fan Speed, Airflow Direction, And Ventilation - Mitsubishi Electric PAR-21MAA Installation

(2) Fan Speed, Airflow Direction, and Ventilation

<To Change the Fan Speed...>
I Press the Fan Speed button 5 as many times as necessary while the system is
running.
• Each press changes the force. The currently selected speed is shown at 5.
• The change sequence, and the available settings, are as follows.
FAN
SPEED
Auto
4-speed
model
3-speed
model
2-speed
model
Note:
G The number of available fan speeds depends on the type of unit connected. Note also
that some units do not provide an "Auto" setting.
G In the following cases, the actual fan speed generated by the unit will differ from the
speed shown the remote controller display.
1. While the display is showing "STAND BY" or "DEFROST".
2. Immediately after starting HEAT mode (while the system is waiting for the mode
change to take effect).
3. In HEAT mode, when room temperature is higher than the temperature setting.
4. When the unit is in DRY mode.
Display
Speed 1 Speed 2 Speed 3 Speed 4
<To Change the Airflow's Up/Down Direction>
I With the unit running, press the Airflow Up/Down button 6 as necessary.
• Each press changes the direction. The current direction is shown at 6.
• The change sequence, and the available settings, are as follows.
Auto
Display
* Note that during swing operation, the directional indication on the screen does not
change in sync with the directional vanes on the unit.
* Some models do not support directional settings.
Note:
G Available directions depend on the type of unit connected. Note also that some units
do not provide an "Auto" setting.
G In the following cases, the actual air direction will differ from the direction indicated
on the remote controller display.
1. While the display is showing "STAND BY" or "DEFROST".
2. Immediately after starting heater mode (while the system is waiting for the mode
change to take effect).
3. In heat mode, when room temperature is higher than the temperature setting.
<To Change the Right/Left Air Direction>
I Press the louver button 7 as necessary.
• The louver image 7 appears.
Each press of the button switches the setting as follows.
No display
(Stop)
(ON) (OFF)
– 9 –
Horiz. 1 2 3 4
During swing operation, the arrow display
move to the left and right.
Swing