Technical Data - merten 5611 serie Gebrauchsanweisung

Toggling the display between showing the time/date,
alarm time, countdown timer and inside temperature
1 Briefly press the "MODE/SET" button to toggle
between the individual displays.
|
The "ALARM" and "COUNT DOWN" displays
change back to the time/date display automatically
after about one minute. The inside temperature
display remains active and can be toggled
manually.
Setting the alarm time
1 Press the "MODE/SET" button again and again until
you are in the "ALARM" display mode.
2 Press the "MODE/SET" for about three seconds.
The hour display flashes.
3 Press the "UP" button to set the hours.
18
5 Press the "UP" button to set the seconds.
6 Press the "END" button to complete the countdown
timer settings.
7 Press the "START" button to activate the countdown
timer. A clock symbol appears in the display.
You can stop the timer at any time by pressing the "STOP"
button.
Switching the alarm tone off (alarm time and
countdown timer)
1 Press the left or right button to switch the alarm tone
off.
Inside temperature displays
1 Press the "MODE/SET" button again and again until
you are in the display mode for the inside
temperature.
Removing the mounting adapter from the surface
upon which it is mounted
Type of installation: Screws
1 Remove the screws from the mounting adapter and
take it off the wall.
Type of installation: Adhesive strips
1 Carefully pull the mounting adapter off the surface.
Make sure that the adhesive strips come off the
surface completely. Use a suitable tool (knife) to help
you remove the mounting adapter if it doesn't come
off easily.
20
4 Press the "SET" button.
The minutes display flashes.
5 Press the "UP" button to set the minutes.
6 Press the "END" button to complete the alarm time
settings.
7 Press the "ON" button to activate the alarm time. A
bell symbol appears in the display.
Setting the countdown timer
1 Press the "MODE/SET" button again and again until
you are in the "COUNT DOWN" display mode.
2 Press the "MODE/SET" for about three seconds.
The minutes display flashes.
3 Press the "UP" button to set the minutes.
4 Press the "SET" button.
The seconds display flashes.
How to dismantle the clock
1 Pull the clock out of
the frame.
2 Use a screwdriver to
remove the frame
from the mounting
adapter.

Technical data

Power supply: 2 x battery of type IEC LR 03
(AAA)
Battery life: About two years
Display/Functions: Time/date
Alarm time
Countdown timer
Inside temperature
Type of protection: IP 20
T
E/ SE T T
E/ SE E/ SE
M OD M OD
M OD
19