merten 5611 serie Gebrauchsanweisung Seite 5

What you can do with the multifunction clock
The multifunction clock (referred to as clock from here
on) displays either the time and the date or the
temperature of the room (in degrees Celsius).
You can set the alarm time for any time of the day.
Additionally, you can set a countdown timer with a
maximum time of 59 minutes and 59 seconds.
It is possible to screw the clock e.g. onto a wall or a flush-
mounted box, or you can stick the clock onto a smooth
surface suitable for mounting with adhesive material. An
additional power supply is not necessary. Two batteries
supply the clock with power.
12
How to change the batteries
_
_
+
+
|
Dispose of used batteries according to statutory
regulations.
¼
Risk of electrocution
Work on the mains voltage must be performed by a
skilled electrician only. Please observe the relevant
regulations in your own country.
Work on the mains voltage is necessary if, for
example:
– You are mounting the device onto a flush-
mounted or cavity wall box with 230 V cables
– An existing switch and socket-outlet
combination has to be dismantled
½
Caution: The device can be destroyed by moisture.
The device must only be installed in a dry room.
|
We recommend a mounting height of about 1.5 m
from the floor. At this level, the display can be read
easily and the temperature sensor is at an optimal
height.
14
A Display
B "UP", "ON", "OFF", "START", "STOP" button
C "MODE/SET", „"MODE", "SET", "END" button
What you need for mounting:
A Clock with batteries
B System M frame
+
C Mounting adapter (included)
D Screws or adhesive strips (included)
_
_
Before mounting
1 Pull out all four
|
Clock functions and displays
MODE/SET
C
How to mount the clock
C
D
corners of the
frame using a pair
of pliers. 4 x
If necessary, use a knife to rework these points.
A
B
B
A
E /S E T
M O D
13