Siemens LOGO! CMK2000 Kompaktbetriebsanleitung Seite 5

LOGO!
CMK2000
Compact Operating Instructions
Application
The LOGO! CMK2000 is a communication module from the
LOGO! family with a KNX interface.
This document is valid for the following products:
LOGO! CMK2000
Design
①
24 V DC connection
②
Status LEDs
RUN: Status of the CMK2000
•
P1: Connection status with LOGO!
•
KNX KNX connection status / programming mode
•
/ warm restart
③
FE functional grounding connection
④
Ethernet connection (LOGO! 8)
⑤
Programming/reset button
⑥
KNX bus connection
⑦
Labeling field for physical address:
© Siemens AG 2015. All rights reserved
A5E36847555A/001, 11/2015
6BK1700-0BA20-0AA0
Safety guidelines
This device corresponds to the approvals printed on the
type plate. If you have questions about whether it is
permissible to install the device in the planned environment,
please contact your service representative.
WARNING
The product/system described in this documentation
•
may only be operated by personnel qualified for the
specific task in hand. Qualified personnel are those
who, based on their training and experience, are
capable of identifying risks and avoiding potential
hazards when working with these products/systems.
Alterations to the devices are not permitted. Failure to
•
observe these guidelines shall constitute a revocation
of the approvals and manufacturer's warranty.
WARNING
Electric shock hazard
May cause death, serious injury or material damage.
Voltages > 60 V can occur in the control cabinet.
•
Suitable safety precautions preventing contact must
therefore be taken before and during commissioning
and maintenance work.
Switch off the power supply and secure against
•
switching on again. All system components must be
off-circuit during installation and connection.
UL-approved cable types must be used for UL-certified
•
systems (60/75°C).
5