Installation - Vetus WS180 Installationsvorschriften

General
The Vetus Water Separators/Fuel Filters
WS180 and WS720 comprise the following
components:
• A fuel filter which collects dirt particles.
• A water separator which separates water
from fuel, by making use of the fact that
water is more dense than the fuel.
The maximum water separation efficiency
of the Vetus WS180 and WS720 water sep-
arators/fuel filters is over 90%. Combined
with the fine filter fitted to the engine, a
water separation of 99% is achieved.
Both types are suitable for either diesel or
petrol fuel.
Two filter elements are connected in paral-
lel in the WS720.

Installation

Remarks
Take into account the regulations as
laid down by the local authorities
concerning the specification and
installation of fuel tanks and fuel
pipes.
Arrangement
Fit the water separator/fuel filter in the fuel
supply pipe between the fuel tank and the
fuel supply pump. Position the water sepa-
rator/fuel filter as close as possible to the
fuel tank in relation to dirt deposits in the
pipe.
Preferably install the water separator/fuel fil-
ter higher than the top of the fuel tank. The
advantage of this is if the filter should leak,
the tank will not run dry. See Drawing 1.
Install a valve at the tank suction connec-
tion.
4
4.0302
Preferably install the whole fuel pipeline so
that it slopes down towards the tank.
All the fine filters installed before or after the
fuel pump must be retained.
Water Separator/Fuel Filter
Take Care!
Filters may never be fitted in such a
way that they 'hang' on the piping,
but should be mounted separately
against a bulkhead or wall.
Mount the filter housing against a vertical
bulkhead.
Ensure that there is sufficient space under-
neath to allow water to be drained from the
filter and to allow the filter element to be
replaced.
Take note of the direction of flow! This is
indicated on the top of the water separa-
tor/fuel filter.
Assemble the fittings in the filter housing
with the gasket rings supplied. Place the
coupling nut and compression ring over
the pipe and screw the whole into the fit-
ting.
Type WS720 has 2 inlet and 2 outlet con-
nections. See 'Overall Dimensions'. Seal
the unused inlet and outlet connections
with the sealing plugs supplied.
Fill the filter element with clean fuel (4).
Lightly lubricate the sealing ring with
engine oil (5).
Screw up tight the new filter element in the
direction indicated. When the sealing ring
contacts the sealing surface (6), tighten the
filter element manually (do not use tools) a
maximum of a half to three-quarters of a
turn (7).
Water separator/ Fuel filter WS180 - WS720