Restore Factory Settings - HomeMatic IP HMIP-SWDO-I Montage- Und Bedienungsanleitung

Restore factory settings

1x orange and
1 x green light-
ing (after insert-
ing batteries)
8 Restore factory settings
Thez factory settings of the device can be
restored. If you do this, you will lose all your
settings.
To restore the factory settings of the window / door con-
tact, please proceed as follows:
Pull the cap (D) off the electronic unit (B). There-
•
fore, press the latch of the cover downwards and
pull down the cover afterwards (see fig. 2). You
will find the battery compartment below (E).
• Remove a battery.
• Insert the battery ensuring that the polarity is cor-
rect and press and hold down the system button
(A) for 4 seconds at the same time, until the LED
will quickly start flashing orange (see figure 3+7).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart.
40
Test display Once the test dis-
play has stopped,
you can continue.