Using The Application In An Action Rule - Axis M3046-V Handbuch

AXIS M3046-V Network Camera
AXIS Video Motion Detection

Using the Application in an Action Rule

The following example shows how to configure the Axis product to record video when AXIS Video Motion Detection 3 detects motion.
1. Insert an SD card in the Axis product, or go to Setup > System Options > Storage in the Axis product's webpages and
configure the product to use a network share.
2. Optionally, go to Setup > Video > Stream Profiles and create a stream profile to use for recording.
3. Go to Setup > Events > Action Rules and click Add to create a new action rule.
4. Configure other settings as required. For example, to only record video during certain time periods, select a Schedule.
5. Under Actions, select Record Video from the Type drop-down list.
6. Select the stream profile and storage device to use and configure the pre- and post-trigger times.
7. Make sure that the rule is enabled and then click OK.
Note
To appear in the Trigger list, the application must be started and its status must be Idle or Running.
35