How To Set Up The Product; Connect The Camera To A Monitor; How To Perform A Basic Setup - Axis M3046-V Handbuch

AXIS M3046-V Network Camera

How to set up the product

How to set up the product
The Axis product can be configured by users with administrator or operator rights. To open the product's setup pages, click Setup in
the top right-hand corner of the live view window.
• Administrators have unrestricted access to all settings.
• Operators have restricted access to settings, see Users on page 44
See also the online help

Connect the Camera to a Monitor

When the camera is first connected to a monitor and then powered up, the default capture mode is automatically set for viewing the
image stream over HDMI. If the camera is connected to a monitor after power up, restart the camera or set the capture mode to
QHD (HDMI)@30/25 fps. This can be done from the Capture mode drop-down list from Video > Camera Settings. This can also be
done from the Configure capture mode window (see Configure capture mode on page 10) after a factory default (see page 56).
Note
It is recommended to use only HDMI certified monitors and cables. For more information see www.hdmi.org

How to perform a basic setup

Basic Setup provides shortcuts to the settings that should be made before using the Axis product:
1. Users. See page 44.
2. TCP/IP. See page 47.
3. Date & Time. See page 46.
4. Video Stream. See page 17.
The Basic Setup menu can be disabled from System Options > Security > Users.
.
16