Usb Charging - auna Areal Bar 355 Bedienungsanleitung

Notes on Pairing
• If there is already an existing connection, press and hold button
on the remote control to re -activate the pairing mode. The existing
connection will be interrupted.
• The unit will also be disconnected when your device is moved beyond
the operational range.
• If you want to reconnect your device to this unit, place it within the
operational range.
• If the device is moved beyond the operational range, when it is brought
back, please check if the device is still connected to the unit.
• If the connection is lost, follow the above instructions to pair your
device again to this unit.

USB CHARGING

You can plug a USB cable (not supplied) in USB socket to charge the mobile
device. Output voltage and current is 5V/500mA. (Note: All devices for USB
charging are not guaranteed)
Note: This device is equipped with an energy saving mode: if no signal
is given during 19 device will switch automatically into standby mode
in order to save energy (ERP 2 standard). Please note that low volume
setting in the audio source may be recognized as "no audio signal": this
will affect the capability of signal detection from the device and can also
originate an automatic switch into standby mode. If this happens please
reactivate the audio signal transmission or increase the volume setting
on the audio source player (MP3 player, etc.), to resume playback. Please
contact the local service centre if the problem remains.
EN
35