System Operation - Audio-Technica M2 Einrichtung Und Betrieb

System Operation

Placement:
Location
System set-up:
1.
2.
3.
See below. Note: Do not set more than
one transmitter to the same frequency. Multiple receivers
may be set to the same frequency.
4.
minimum position Note: At this point, check to be certain the
RF indictor is not illuminated. If it is illuminated before you
have powered on the transmitter, this means the frequency
you have chosen is already in use. Choose another frequency.
5
6.
7.
How to select a frequency
1.
2.
3.
Note: Because these frequencies are shared with TV broadcasting
(depending on country of use), frequency selection is largely
dependent upon which TV broadcast channels are in operation
where the wireless system is to be used.
Squelch Control
with volume in
see page 6
Audio set-up:
8.
audio signal through your transmitter (to another transmitter
or recording device, for instance), use the Loop output connectors
on the back of the M2T Stereo Transmitter. The R/2 XLR jack
duplicates the unprocessed signal of the R/2 input; the L/1 XLR
jack duplicates the unprocessed signal of the L/1 input.These
are not affected by front panel settings.
9.
10.
11.
See below.
12.
NOTE: Do not put the earphones in your
ears at this point.
13.
14.
Setting Levels
trim control
Aux In jack
Note: If you connect a stereo source (such as an MP3 player)
into the M2R Stereo Receiver's Aux Input, be certain to use a
mono adapter to protect your equipment from the DC voltage
that is applied to the ring of the stereo connector.
Note: If you want to send the
minimum position
minimum position
See L/1 and R/2
see page 7
see page 7