Pioneer SE-MS9BN Bedienungsanleitung Seite 21

8. Vocal communication
To use the wireless headphones for vocal communication, pairing must be per-
formed with the desired Bluetooth device using the "hands-free profile" (HFP) or
"headset profile" (HSP).
For details on how to perform pairing, see P.4.
* If the Bluetooth device supports both profiles HFP and HSP, use the profile HFP.
(1) With power to the wireless headphones' turned off, hold the (
depressed for about three seconds.
The headphones' power will turn on and the LED indicator will flash blue.
(2) Turn on the Bluetooth function on the device you wish to connect to.
When pairing is completed, the wireless headphones will automatically connect
to the Bluetooth device.
* If automatic connection is not achieved, or the headphones automatically connect
to a different Bluetooth device than the one you wish to use, follow the instructions
for the desired Bluetooth device regarding manual connection.
Vocal communication controls
If the connected Bluetooth device supports AVRCP, the following operations can be
used.
• ( + ) button
Press and hold : Increase volume.
• ( – ) button
Press and hold : Decrease volume.
• Play / Pause button
Press once when receiving a message : Enables conversation.
Press once again to end conversation.
Press and hold when receiving a message : Refuse communication.
Press twice : Performs redialing.
The same controls are supported in the event a call is received while listening to
music.
* When sound volume is set to maximum or minimum levels a beep sound will be
produced from the headphones.
* Sound volume can be adjusted on the matching Bluetooth device.
* Depending on the specifications of the connected Bluetooth device, the controls
noted above and controls on the Bluetooth device may not be supported.
* Depending on the specifications of the connected Bluetooth device, the phone
settings may need to be configured. Consult the user's manual for the Bluetooth
device.
9. Using the voice assist function
<How to use the Google Assistant>
You can search using the microphone of the headphones by running the Google
Assistant installed on a smartphone or other device.
Compatible smartphones
Android 5.0 or later (The Google
TM
) button
version.)
iOS (The Google Assistant app needs to be installed.)
<Android devices>
When you pair the device with the headphones, a pop-up for connecting with the
Google Assistant starts.
Make the connection following the guidance.
<iOS devices>
Install the Google Assistant app and run it.
When you pair the device with the headphones, a pop-up for connecting with the
Google Assistant starts.
Make the connection following the guidance.
*For the pairing procedure, see "4. Pairing".
• Assistant button
Press and hold : Voice input (Voice is input while you press
and hold down the button. Release the button to finish.)
Press once : Reading notifications
Press twice : Cancelling reading
*Depending on the specifications of the connected Bluetooth device, the controls
noted above and controls on the luetooth device may not be supported.
*For detailed Google Assistant operations, refer to the Google Assistant web page.
*When the Google Assistant is not available due to no connection to any network or
for other reasons, an audio guidance "The Google Assistant is not connected" is
played.
*The Google Assistant function is not available in some countries and areas as well
as in some languages.
8
En
app needs to be updated to the most current
TM