Hama 00053145 Bedienungsanleitung Seite 18

g Operating Instruction
D:\Treiber\XP\32Bit (Note that you may need to enter the
letter assigned to your disk drive instead of D). Then click
→ Next.
6. After the driver has been copied to your system, the
Hardware Wizard reports that installation is complete.
Remove the driver CD-ROM from your drive and then click
→ Finish.
7. Restart Windows XP and set up the connected hard drives
as required.
You can check whether the controller was installed properly
under Start → Control Panel → Performance and Maintenance
→ System → Hardware → Device Manager. The following entry
must appear without a yellow exclamation mark.
SCSI and RAID controllers:
• JMicron JMB36X controller
Note: We highly recommend that Window XP users install
Service Pack 3 due to enhancements and improved
functionality.
For Windows XP in the x64-Bit Version:
1. First install the hardware as described in the manual and
start up Windows.
2. As soon as Windows has booted up, the Add Hardware
Wizard appears and asks you whether Windows can
connect to the Internet to search for a suitable driver with
Windows Update. Select the option → "No, not this time"
and click→ Next to continue installation.
3. Next, you will be asked to insert a floppy disk or CD so that
you can install the driver. When you have inserted the
enclosed CD, select the second of the two options: "Install
software from a list or particular source (for advanced
users)". Click → Next. (If the autostart menu of the Hama
CD-ROM is displayed first, exit it.)
4. In the next step, "Select search and installation options",
select the following options:
• Search for the best driver in these locations
• Include this location in the search:
5. Enter the save location for the driver in the active entry field.
D:\Treiber\XP\64Bit (Note that you may need to enter the
letter assigned to your disk drive instead of D). Then click
→ Next.
6. After the driver has been copied to your system, the
Hardware Wizard reports that installation is complete.
Remove the driver CD-ROM from your drive and then click
→ Finish.
7. Restart Windows XP and set up the connected hard drives
as required.
You can check whether the controller was installed properly
under Start → Control Panel → Performance and Maintenance
→ System → Hardware → Device Manager. The following entry
must appear without a yellow exclamation mark.
SCSI and RAID controllers:
• JMicron JMB36X controller
Note: We highly recommend that Windows XP x64Bit users
install Service Pack 2 due to enhancements and improved
functionality.
Safety instructions:
Keep this device away from heaters and radiators and free of
dust or moisture when operating.
Support information:
Contact your dealer or Hama Product Consulting if you have a
faulty product:
Support Hotline – Hama Product Consulting:
Tel.: +49 (0) 90 91 / 502 – 115
Fax: +49 (0) 90 91 / 502 – 272
E-mail: mailto:produktberatung@hama.de
Product information and new drivers can found on the Internet
at www.hama.com
17