Pioneer S-LM2-LR-K Bedienungsanleitung Seite 4

Attaching and removing the grille
It is recommended that this speaker system be used with the grille
net attached, but it can be removed if desired. To remove, follow
these instructions:
1 To remove the grille, place your hands at the bottom of
the grille and pull gently outward.
Do the same at the middle of the grille, then at the top to
detach.
2 To reattach the grille, align the four holes on the corners
and two on the middle of the grille's back with the pins on
the speaker and press in firmly.
4
En
Connections
1 Switch off the power of your amplifier.
2 Connect the speaker cables to the input terminals (lower)
on the back of the speaker. For input terminal polarity, red is
positive (+) and black is negative (–).
Red terminal (+)
Black terminal (–)
Speaker cable (white without line)
3 Connect the other ends of the cables to the amplifier's
speaker output terminals (for more details, refer to your
amplifier instruction manual).
• You can also connect the speaker's terminals with a banana
plug.
• When using a banana plug, first remove the caps covering the
speaker terminal.
• Grasp the cap knobs on the lower input terminals and rotate
them to the left (counter-clockwise), insert the speaker cable
wires into the holes in the terminal posts, then tighten the
knobs to secure the short bar as well as the wires.
• After connecting the plugs, pull lightly on the cables to make
sure that the ends of the cables are securely connected to the
terminals. Poor connections can create noise and
interruptions in the sound.
• If the cables' wires happen to be pushed out of the terminals,
allowing the wires to come into contact with each other, it
places an excessive additional load on the amplifier. This may
cause the amplifier to stop functioning, and may even damage
the amplifier.
• When using a set of speakers connected to an amplifier, you
won't be able to obtain the normal stereo effect if the polarity
(+, –) of one of the speakers (left or right) is reversed.
CAUTION
These speaker terminals carry HAZARDOUS LIVE
voltage. To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
Speaker cable
(white with line)
D3-4-2-2-3_A1_En