How To Install; Choosing Where To Place The Speaker Systems - Pioneer S-LM2-LR-K Bedienungsanleitung

How to install

Choosing where to place the speaker systems

20 cm
7
(7 / in.)
8
from the
back wall
50 cm
11
(19 / in.)
16
from the side
wall
• Sounds played through speaker systems are easily affected in
subtle ways by the conditions in the listening space.
• For best sound, choose a solid floor upon which to place the
speakers, and position the speakers as shown below. The level
of low sounds can be adjusted by moving the speakers closer
to or further from the back wall. Adjust the speakers so that
they are equidistant from their respective side walls to assure
balanced sound.
• Place the left and right speakers equal distances from your
listening position for good stereo sound. Use speaker cords of
the same length for each speaker.
• So far as possible, place the front left and front right speakers
on the same plane as the TV screen.
• To achieve optimum surround sound, you should place the TV
between the left and right speakers, with the speakers
pointing at a 50 to 60 degree angle toward the listening
position.
• If the room has a lot of reverberation, we recommend hanging
heavy fabric on the walls, and/or putting a carpet on the floor
to damp the sound. For best results, cover walls completely.
• Pioneer is not responsible for any accidents or damage that
result from improper installation, misuse or modification of
the product, or natural disasters.
• Since these speaker systems are quite heavy, do not install
them in unstable locations; a falling speaker could result in
damage or dangerous personal injury.
• When installing these speaker systems, be sure to provide
positive measures against tipping or falling, since accidental
falls due to earthquakes or other causes could result in injury.
Applying non skid pads
The use of non skid pads is recommended depending on the
installation location. Apply the pads to the four corners of the side
of the speaker which will be on the bottom. Note that depending
on the location, the pads may not provide fully sufficient traction
to prevent slipping, so care should be taken not to install the
speakers in conditions where they may be prone to slide.
Mounting the Fall-Prevention Fixing bracket
50 60
• Make sure that the wall you intend to mount the speakers on
is strong enough to support them.
• Pass a commercially-available reinforced string through the
fixing bracket to securely support the speaker to the wall. Be
sure that the wall to which you fasten the speaker is strong
enough to support the weight of the speaker. After fastening
the speaker, make sure that it does not fall over.
• The speaker can incur damage in the event of a fall.
• Do not attach the fixing bracket directly to the wall. It should
only be used in conjunction with reinforced string to prevent
the speaker from falling.
• Do not install your speakers overhead on the ceiling or wall.
The grill is designed to be detachable, and as such it may fall
and cause damage or personal injury if installed overhead.
Pass two reinforced strings through the fixing bracket, and
fasten the speaker to the wall as shown above.
Non skid pad
Fixing bracket
Reinforced strings
Speaker's rear view
3
En