Network Connection - Samsung LE46A956 Bedienungsanleitung

Network Connection

Network Connection - Cable
Cable Connection for a DHCP Environment

The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP
address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them
manually.
1. Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable.
2. Connect the LAN port on the wall and the external modem with a Modem Cable.
The terminals (the position of the port and the type) of the external device may differ depending on the manufacturer.
N
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at least 10
N
seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner's manual of the corresponding
N
product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router).
N
You cannot use a manual-connection-type ADSL modem becaus;e it does not support DHCP. You have to use an automatic-
N
connection-type ADSL modem.
BN68-01737M-ENG.indb 26
The Modem Port
on the Wall
External Modem
(ADSL / VDSL / Cable TV)
Modem Cable
2
You can connect the LAN via a Sharer (Router).
External Modem
The Modem
(ADSL / VDSL / Cable TV)
Port on the Wall
Modem Cable
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port
on the Wall
LAN Cable
TV Rear Panel
LAN Cable

IP Sharer
TV Rear Panel
LAN Cable
LAN Cable
TV Rear Panel
English - 2
2008-08-27 ¿ÀÈÄ 2:53:01