Samsung HT-J5150 Bedienungsanleitung Seite 9

Installing the Speakers on the Tallboy Stand
1. Turn the Stand Base upside-down and connect
it to the Stand.
2. Use the driver to combine the screws on the 3
marked holes.
3. Straighten a supplied speaker wire and put in
the hole on the centre of Stand Base.
4. Connect the upper Speaker to the assembled
Stand.
5. Insert a screw clockwise into the hole on the
rear of the speaker using a screwdriver.
And then connect a speaker cable.
6. This is the appearance after the speaker is
installed.
Follow this steps to install other speaker.
Speaker Cable Connections
* Front/Surround Speakers only
1. Match each speaker cable bundle to the correct speaker by matching the colour coded plug on each
bundle to the coloured sticker on the bottom of each speaker.
2. Connect the speaker wire plugs from each speaker to the back of the product by matching the colours of
the speaker plugs to the colours of the speaker jacks. When connecting, make sure to match label colour
on the back of speaker.
1
Stand Base
Stand
3
5
9
- English
2
4
Speaker
Stand
6