Delivery Contents; About This Product - Aventics AS1 Betriebsanleitung

AVENTICS | AS1 / AS2 / AS3 / AS5 | R412013438–BAL–001–AD | English
General safety instructions
W
Observe the valid local regulations in the country
of use to protect the environment and avoid workplace
accidents.
W
Only use AVENTICS products that are in perfect
working order.
W
Examine the product for obvious defects, such
as cracks in the housing or missing screws, caps,
or seals.
W
Do not modify or convert the product.
W
Persons who assemble, operate, disassemble, or
maintain AVENTICS products must not consume any
alcohol, drugs, or pharmaceuticals that may affect
their ability to respond.
W
The warranty will not apply if the product is incorrectly
assembled.
W
Do not place any improper mechanical loads
on the product under any circumstances.
W
Product warnings and information must be legible,
i.e. not covered by paint, etc.
Safety instructions related to the product
and technology
W
Lay cables and lines so that they cannot be damaged
and no one can trip over them.
W
Do not operate the product in aggressive ambient air
(e.g. solvent vapors).
3

Delivery Contents

The delivery contents include:
W
1 distributor as ordered
W
Operating instructions
W
Additionally in case of AS2, AS3:
1 molded seal, 1 flat gasket
4

About this product

Distributors are components of maintenance units and are
used to distribute compressed air. Pressure switches may
be additionally mounted in flange and pipe connections.
The following versions are available:
W
DIS:
Standard distributor
W
DIC:
Distributor with center infeed
W
DIN:
Distributor with non-return valve
The following table lists assignment to the maintenance
units:
AS1 DIS
DIN
AS2 DIS
DIC
DIN
AS3 DIS
DIC
DIN
AS5 DIS
DIN
5 Assembly, Commissioning
and Operation
O Let the product acclimatize for several hours before
commissioning, otherwise, water may condense in the
housing.
Danger of injury if assembled under pressure
or voltage!
Assembling when under pressure or electrical voltage
can lead to injuries and damage to the product
or system components.
O Make sure that the relevant system part is not
under voltage or pressure before you assemble
the product.
O Protect the system against being switched on.
Sudden rise in pressure during commissioning!
The system is exposed to sudden pressure on
commissioning if no SSU filling unit is used! This may
result in dangerous erratic cylinder movements.
O Please ensure when commissioning a system
without a SSU filling unit that the cylinders are in
their end position or that no danger can emit from
those not in end position.
2-fold
Non-return valve
3-fold
4-fold
Non-return valve
4-fold
4-fold
Non-return valve,
4-fold
2-fold
Non-return valve,
0-fold
CAUTION
7
I
IV
II
III
IV
III
III
V
I
VI