Safety Regulations; For A Safety Conscious Work Environment - egger EL 3 Betriebsanleitung

2

Safety Regulations

The electrical light-curing unit egger EL 3 is used for the polymerization of
UV-curing modeling pastes and lacquers. A use other than described in the
instruction manual may lead to injuries of the operator or of third persons.
Furthermore, the device or other material assets may be damaged. The
device must be used in technically perfect condition only and the safety
regulations must be strictly complied with.

For a safety conscious work environment

2.1
On self-accomplished repairs or if other spare parts are used, all guarantee
and liability claims will become extinct!
• Protect the unit from dust. Use the unit on dry working places only.
• Qualified and trained persons must use the device only.
• Before putting the device into operation, the user has to read the
instruction manual and ask the manufacturer in case of any
questions.
• Use the unit in perfect and clean conditions only and with full
operational light tubes.
•
Connect the device to permissible sockets only.
•
Please adhere to the acknowledged safety regulations.
• This device is used for the processing of UV-curing materials in a
spectral range of 360 - 390 nm. Please also adhere to the processing
manual for each material to be worked with.
• Do not pull the mains plug out of the socket at the mains cable.
• Should the mains cable be damaged, it must be replaced at once.
Defective mains cables must not be used.
•
The device must be repaired by the manufacturer only.
• The unit must be switched off during service and maintenance
operations (cleaning, replacing of UV-bulbs or reflecting foil). Pull the
mains cable out of the mains plug!
• When replacing use the original egger light tubes and reflectors
only.
• Do not use any dissolvent when cleaning the device. Do not
immerse the unit in liquids.
•
Children must be kept away from the unit!