Safety Regulations - egger EL 4 Betriebsanleitung

2

Safety Regulations

The electrical light-curing unit egger EL 4 is used for the polymerization of UV-
curing modeling pastes and lacquers. A use other than described in the operat-
ing instructions may lead to injuries of the operator or of third persons. Further-
more, the device or other material assets may be damaged. Therefore, the de-
vice must be used in technically perfect condition only and the safety regula-
tions must be strictly complied with.
2.1 Working according to the safety regulations
•
On self-accomplished repairs or if other spare parts are used, all guarantee and
liability claims will become extinct!
EL 4_51205_D_E.doc
• Protect the unit from dust. Use the unit on dry working places only.
• Qualified and trained persons must use the device only.
• Before putting the device into operation, the user has to read the oper-
ating instructions and ask the manufacturer in case of any questions.
• Use the unit in perfect and clean conditions only and with full opera-
tional light tubes.
• Connect the device to permissible sockets only;
• Please adhere to the safety regulations accepted.
• This device is used for the processing of UV-curing materials in a spectral
range of 360 - 390 nm. Please also adhere to the processing manual for
each material to be worked with.
• Do not pull the mains plug out off the socket at the mains cable.
• Should the mains cable be damaged, it must be replaced at once. De-
fective mains cables must not be used.
• The device must be repaired by the manufacturer only.
• The unit must be switched off during service and maintenance opera-
tions (cleaning, replacing of UV-bulbs or reflecting foil). Pull the mains
plug before!
• On replacing use the original egger light tubes and reflectors only.
• Do not use any dissolvent when cleaning the device. Do not immerse
the unit in liquids.
Children must be kept away from the unit!.
Seite / Page 14 von / of 20