Nameplate - Sulzer Abs Rw 7511 Einbau- Und Betriebsanleitung

Installation and Operating Instructions
RW 7511
1.8

Nameplate

See chapter 1.8 of the Installation and Operating Instructions 15970832-EU/0833-EU.
2 - 3 Safety; Transport and storage
See chapter 2 - 3 of the Installation and Operating Instructions 15970832-EU/0833-EU.
4 Product description
4.1 General description
See chapter 4.1 of the Installation and Operating Instructions 15970832-EU/0833-EU.
4.2 Structural design RW 7511
6 5 8
7 9
4.3 Operation with frequency inverters
See chapter 4.5 of the Installation and Operating Instructions 15970832-EU/0833-EU.
5 Installation
See chapter 5 of the Installation and Operating Instructions 15970832-EU/0833-EU.
5.1 Installation RW 7511
See chapter 5.1 of the Installation and Operating Instructions 15970832-EU/0833-EU.
5.2 Propeller assembly RW 7511
The propellers of the RW 7511 are supplied separately and must be fitted on site in accordance with the instructions below.
ATTENTION Take care that the orientation of the lock washers is correct (Figure 17 Correct fitting posi-
tion of the securing washers in chapter 5.3 of the installation and Operating Instructions
15970832-EU/0833-EU) and that the prescribed tightening torque is used!
1. Lightly grease propeller boss and shaft end.
2. Push on propeller (3/6).
3. Fit O-Ring (3/5).
4. Insert propeller washer (3/2).
5. Fit O-Ring (3/4).
6. Fit lock washers (3/3) taking care that orientation is correct
7. Tighten socket head screw (3/1) with torque of 56 Nm.
6
4 3
Figure 2 RW 7511
Legend
2
1
1 Bracket
2 Cable inlet
3 Bracket with shackle
4 Stainless steel covering (Option)
5 Mechanical seal
6 Propeller boss
7 Propeller
8 Shaft unit with rotor and bearings
9 SD - ring
GB 1581-C