Energetics BT 660 Gebrauchsanweisung Seite 4

Assembly
1: Take off the pin from the frame, open the frame, put the frame stand on the ground. Align the holes of the
frame (1) and the front stabilizer, insert the pin (39) to the holes.
Note: When you fold your stepper, take off the pin (39), fold the stepper as figure 1, and then insert the pin to
the hole in the front supporting tube.
2: Attach the rear stabilizer (4) to the frame (1) with two carriage bolts (36), curve washers (38) and cap nuts
(37). Make sure the transportation wheels (35) face outside.
Note: Make sure you fasten the bolts securely to avoid shaking and discomfort when peddling.
Note: How to adjust the hydraulic cylinder. The cylinder has 12 sections, the bigger the number is, the bigger
the resistance is. Turn the top of the cylinder clockwise, the resistance will become bigger. The number which
the arrow point is the exact section.
3: Connect up plug of sensor cable to the socket of the computer, insert the computer to the top of the oval tube
of the frame (1).
Attach the handlebar to the bracket of the frame. Insert the plug of hand pulse cable to the socket of the
computer. Plug four plastic caps on the nuts. Note: make sure you fasten the bolts securely to avoid shaking
when pedalling.
Computer
1. TIME: Automatically accumulates workout time when starting exercise.
2. COUNT: Automatically accumulates workout counts when starting exercise.
3. TOTAL COUNT: Automatically accumulates different sessions workout counts when starting exercise.
4. CALS: Automatically accumulates calories amount consumed when starting exercise.
5. PULSE (Option): Automatically detects and displays your current heart rate when exercising.
6. MODE: Button to activate the computer. To select functions of time, count, total count, calories and
pulse (if available). Hold the button for 2 seconds to have a total reset.
Importantly
1. The value of pulse function is for reference only, please do not consider as medical purposes.
2. If there is a possibility to see an improper display on the monitor, please replace the batteries to have a
good result.
3. Please use 2 pcs of 1.5V AA batteries as a power supply.
4. The monitor will be automatically shut off if there is no signal coming in for 4 to 5 minutes.
5. The monitor will be auto-powered when start exercise, push button or insert pulse cable w/signal in.
Training
After activating the computer you may start exercising.
The rates for distance, time, accumulated distance and energy consumption will be counted upwards.
By pressing button 7, the rates can be recalled.
The mark indicates, which rate is presently displayed.
Is the mark at Scan, the automatic run-through is activated. Each rate will be shown for 6 seconds.
After having finished a workout, the achieved rates will be shown for 4 minutes. If you continue training in the
meantime, the data will also continue to be accumulated.
4