Care, Maintenance And Storage; Troubleshooting Guide - Cocraft HWD30S Bedienungsanleitung

Blower function
Connect the suction hose to the air outlet (11). Bear in mind that any dust or waste particles left
inside the suction hose will be blown out when the vacuum cleaner is switched on.

Care, maintenance and storage

• Always unplug the product from the wall socket before cleaning.
• Clean the exterior of the vacuum cleaner using a damp cloth. Use only mild cleaning agents,
never solvents or corrosive chemicals.
Cleaning the cartridge filter
1. Make sure that the vacuum cleaner is unplugged from the mains.
2. Remove the filter.
3. Brush or shake any dirt and debris off the filter (in an appropriate outdoor area).
4. Refit the filter.
Cleaning the foam filter
1. Make sure that the vacuum cleaner is unplugged from the mains.
2. Remove the filter.
3. Hand wash the filter with mild soapy water and then rinse well with clean water.
4. Allow the filter to air dry. Refit the filter only when it is completely dry.
If the wet and dry vacuum cleaner is not to be used for
an extended period
Unplug the vacuum cleaner and make sure that all the parts are dry.
Store it in a dry place out of children's reach.

Troubleshooting guide

The wet and dry vacuum
cleaner won't start.
Poor suction and
high motor speed.
• Make sure that the mains lead is undamaged and securely
plugged into a wall socket.
• Is the wall socket energised?
• Dust bag is full, change the bag.
• The container is full of liquid, empty it.
• Nozzle, hose or coupling clogged. Check and clean as required.
8