Specifications - Mitsubishi Electric AL-ASI-BD Hardwarehandbuch

This manual contains text, diagrams and explanations which will guide the reader in the
ENG
correct instruction and operation of the AL-ASI-BD AS-Interface module. It should be read and
understood before attempting to install or use the unit. Further information can be found in the
α
HARDWARE and PROGRAMMING MANUALS.
Caution
•Persons trained in the local and national electrical standards must replace the AL-ASI-BD.
•Turn off the power supply when you install or remove the AL-ASI-BD.
•Replace the cover after removing the AL-ASI-BD.
•Under no circumstances will Mitsubishi Electric be liable or responsible for any consequential
damage that may arise as a result of the installation or use of this equipment.
1. INTRODUCTION
The AL-ASI-BD Actuator Sensor Interface board module (Hereafter referred to as the AL-ASI-BD) is used
in conjunction with an AL-20MR-A, AL-20MR-D or AL-20MT-D
over an Actuator Sensor interface (AS-Interface) network.
The AL-ASI-BD connects onto the main body of the
AS-Interface network (Input 4 points, Output 4 points). A maximum of 31 slaves can be connected to form
an AS-Interface network. Power for the communication is supplied over the AS-Interface bus by the
AS-Interface power supply. The communication signal is superimposed over the power supply on the AS-
Interface bus.

2. SPECIFICATIONS

For general specifications please refer to the
Table 1. Hardware Communication Specifications
Item
Number of I/O
I/O Refresh Time
Network Distance
External Power Voltage
External Power Current
Consumption
Complies with
Table 2. Software Communication Specifications
Item
Station Number
IO Code
ID Code
Data Bit D0 - D3
P0
Parameter Bit
P1,P2,P3
M6
System Bit
M7
Control Bit N1
*1 Function to reset input signal (E01 - E04) when AS-Interface communication is cut for 70 ms or more.
α
*2 Displayed in controllers system Bits M6, M7 & control Bit N1.
α
HARDWARE MANUAL.
4 Input (in. E01-E04) 4 Output (Out. A01-A04)
Max. 5ms
Max. 100m
Typ. 30.5V DC (AS-Interface Power supply)
40 mA or less
ASi Certification, CE
Set by Master Station (Factory default 0)
7
F
Input Output 01 - 04 (E01 - E04, A01 - A04)
Communication monitor (set by default).*1
Unused
Communication Error *2
Communication Error - ASi Power Supply *2
Active - Passive switch *2
α
series controller for data communication
α
series controller, forming a slave station for an
Content
Content