Zippie Neptune Gebrauchsanweisung Seite 21

Castors Lift base and check each wheel to ensure it is not damaged, loose or worn.
Removing any grease or dirt that has built up on the wheels, check that the brakes stop the wheels rotating.
Brakes Check they are securely fixed in place & that there are no signs of damage or wear & tear.
Pushing Handles Ensure handles are functioning correctly.
Check there are no signs of damage or wear and tear.
Ensure push handle grips are secure.
Seat Tilt In Space With the tilt lock released check for free movement with no signs of damage or wear to the mechanism, lever or
Mechanism cables.
Tighten the lock and ensure it holds the seat angle.
With the seat unloaded, press the lever & ensure it moves freely to the maximum height.
Base Height In incremental stages add weight up to the maximum load (40, 60, 80 or 100kgs) and, over a period of time
Adjustment (approx 10 - 15 minutes), check that there is no creep (lowering) of the seat. If it is not practical to perform this
test, as a minimum requirement, immediately following the maintenance check, the static position of the seat
should be monitored whilst a user is positioned in the system.
With the load on, press the lever & ensure the seat travels freely to the lowest position.
Seat / Backrest Check the attachment points of the seat and backrest upholstery are tight.
Upholstery Check for worn covering. Rough worn upholstery can cause discomfort, would be difficult to keep hygienically
clean, and may cause skin irritation.
Interface Check there are no signs of damage or wear and tear.
Ensure the function secures the seating unit properly.
Frame
With correct
maintenance the
Check all metal parts to ensure there are no signs of damage or wear and tear, paying particular attention to
frame should
adjustable or moving parts.
provide at least 5
Check there are no signs of failure in joints and welds.
years trouble free
Check tightness & security of all fixings, bolts, nuts, spring loaded pegs, & other fitments.
use but,
Check for signs of fatigue wears, replace parts that show signs of wear or repeatedly becoming loose.
depending on
ANCHOR POINTS (where applicable) for transportation must be checked to ensure security, check there are
conditions of use,
no signs of damage, wear and tear or failure.
wear will occur
and a thorough
inspection is
recommended.
Fixtures Check arm pads and headrest and replace if worn.
Neptune Rev.2.0
Maintenance Table
21