Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10.0 Seat Depth-Adjustments
WARNING!
•
When mounting the seating system to a base for the first
time, or when an adjustment has been made to the size of
the system, a stability assessment should be carried out
prior to use of the equipment.
•
Once you have adjusted the seat length, always ensure
these points are firmly fixed and are checked as part of
maintenance of the chair.
Adjusting the Seat Depth
•
Pull out plungers (A) located on both sides of the seat,
(Fig.10.1-10.2).
•
Slide the seat in or out to change the length.
•
Release the plungers and continue to slide until the frame
locks into place.
NOTE:
•
When increasing the seat depth it is best to stand at the
rear of the chair with the brakes applied and pull the back
frame towards you.
•
When reducing the seat depth you should do the same
whilst standing at the front of the chair.
Fig.10.1
A
Fig.10.2
A
14
11.0 Back Angle-Adjustments
WARNING!
Always ensure that the back is secure and that the levers are
tightened before using the chair.
Adjusting the Back Angle
•
Open the levers (A) on both sides of the chair and angle the
back to the desired position by pulling up or pushing down
bar (B). Fig.11.1-11.2.
•
The back will click into position as you change the angle.
•
When the desired back angle has been reached, hinge
closed the levers to secure the back in place.
Fig.11.1
A
Fig.11.2
A
B
Neptune Rev.2.0
Werbung
Kapitel
Inhaltsverzeichnis
