Leg Rest Adjustment; Legrest Detachment / Attachment; Legrest Length (3 Positions); Footplate Angle / Flip Away - Zippie Neptune Gebrauchsanweisung

20.0 Leg Rest Adjustment

Legrest Detachment / Attachment

• Pull and lock open plunger A1 (by rotating 90°) which is on
the right hand side of the seat as you are looking at the
chair.
• Pull and hold open the plunger A2 which is (on the left side
of the seat as you are looking at the chair) to enable you to
disengage the legrest from the main seating unit.

Legrest Length (3 positions)

• Hold open plunger (B) on the back of the leg rest post and
re-locate into one of the holes in the legrest stem.
NOTE: Viewed from back of seat.
Fig.19.1
A
1
D
21.0 Leg Rest Adjustment

Footplate Angle / Flip Away

• Using plungers (C) on either side of the chair, select the
relevant hole and release the plungers into the hole to
secure the footplate in place.
• The footplate can be flipped up manually to allow clearance
for standing transfers etc.

Footplate Height / Length

• Loosen bolt (D) by half a turn with a 4mm allen key so you
can slide the footplate up and down the leg stem.
NOTE: For the shortest length raise the footplate up the leg
stem to the minimum and close the leg stem to the minimum
setting.
Fig.20.1
Neptune Rev.2.0

22.0 Sandal/Foot Strap Adjustment

Sandal Fixing

•
•
•

Foot Straps

Do not use foot straps unless the client is wearing shoes.
Foot straps or ankle supports can be attached through the slots
B
in the sandal to secure feet.
•
•
A
2
C
Underneath the footplate loosen the central allen key bolt
turning anti-clockwise.
Rotate the sandal to the desired position along slot (E).
Fix in place by tightening the allen key bolt beneath the
footplate.
WARNING!
Feed the strap through the buckle and close the buckle shut
to secure.
Alternatively a fixing kit can be supplied to fit the ankle
supports directly to the footplate.
Fig.21.1
E
Fig.21.2
E
19