Tool Specifications; Machine Elements; Noise/Vibration Information; Intended Use - Bosch GSH 3 E PROFESSIONAL Bedienungsanleitung

Tool Specifications

Demolition Hammer
Order number
Rated input power*
Impact rate
Impact energy per
stroke
Chisel positions
Chiselling
performance in
concrete of medium
hardness
Tool holder
Spindle collar
diameter
Lubrication
Weight without cable,
approx.
Protection class
Please observe the order number of your machine. The
trade names of the individual machines may vary.
* The values given are valid for nominal voltages [U] of
230/240 V. For lower voltages and models for specific
countries, these values can vary.

Noise/Vibration Information

Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the ma-
chine are: sound pressure level 87 dB (A); sound
power level 98 dB (A).
uncertainty K = 3 dB.
Wear hearing protection!
The typically weighted acceleration is 10 m/s

Intended Use

The machine is intended for chisel work in con-
crete, brick and masonry as well as for the re-
moval of tiles, plaster, adhesive remainders and
stucco when using the respective accessories.
8 • 1 619 929 621 • TMS • 04.03.04
GSH 3 E
PROFESSIONAL
0 611 320 7..
[W] 650
[bpm] 0 – 3 500
[J] 4.3
12
[kg/h] 31
SDS-plus
[mm] Ø 56
Oil lubrication
[kg] 3.5
/ II
Measurement

Machine Elements

The numbering of the machine elements refers to
the illustration of the machine on the graphics
page.
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Dust protection cap
2 Locking sleeve
3 Chisel adjusting ring (Vario-lock)
4 Lock-on button for On/Off switch
5 On/Off switch
6 Auxiliary handle
Not all of the accessories illustrated or described are
included as standard delivery.
SAVE THESE INSTRUCTIONS.
When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held more
secure than by hand.
Always wait until the machine has come to
a complete stop before placing it down. The
2
.
tool insert can jam and lead to loss of control
over the power tool.
Do not use a machine with a damaged
mains cable. Do not touch the damaged ca-
ble and pull the mains plug when the cable
is damaged while working. Damaged cables
increase the risk of an electric shock.
Connect machines that are used in the
open via a residual current device (RCD).
Wear ear protection. Exposure to noise can
cause hearing loss.
Always use the auxiliary handle supplied
with the machine. Loss of control can cause
personal injury.
English - 1
For Your Safety
Read all instructions. Failure to
follow all instructions listed below
may result in electric shock, fire
and/or serious injury.