Program Settings - Nice Rmu 40 Installateurhandbuch

GB

Program settings

1. Hold the back button in RMU 40 for 7 seconds to
access the menu "service settings".
2. Enter the menu and select which climate system
RMU 40 should be connected to.
3. Start the heat pump /indoor module, go to menu
"system settings" (5.2) and activate RMU 40 for
the climate system that you want to control with
the room unit.
4. If you wish the heat pump/indoor module to use
the room sensor to control the temperature, set it
in menu "room sensor settings" (1.9.4). If an extern-
al room sensor (BT50) is installed it will be used.
Otherwise the room sensor in RMU 40 is used.
NOTE
The software in the heat pump/indoor module
must be version 1199 or higher to work with
RMU 40 .
18
Control - Introduction
Room unit
A
B C D E
Display
A
Instructions, settings and operational informa-
tion are shown on the display.
Stand-by button
B
RMU 40 can be switched to stand-by mode
using the standby button. The heat pump/in-
door module operation is not affected by
pressing the button.
Back button
C
The back button is used to:
■
go back to the previous menu.
■
change a setting that has not been con-
firmed.
OK button
D
The OK button is used to:
■
confirm selections of sub menus/options/set
values.
Up and down buttons
E
With the up and down buttons you can:
■
scroll in menus and between options.
■
increase and decrease the values.