Use Of The Control Display; Presentation; Setting Of The Temperature - Zodiac Red Line 3 Montage- Und Gebrauchsanleitung

Single-phase power supply connection
Heater terminal Protection with 30 mA differential
strip circuit breaker at line head
shunts
Filtration
electric box
Single-phase power supply: 230Vac (S terminal) + Neutral (C
terminal) + Earth

5. USE OF THE CONTROL DISPLAY

5.1 Presentation

The "Bazic" control unit fitted in the front side is equipped with:
- a digital display of 2 digits (1), to display the current and required pool's
temperatures,
- two sensitive switches to adjust the required temperature (2),
- a sensitive "on/off" switch (3),
- an "on/off" led ("on": led green)(4),
- an operation state led (5),
=> while heating: fix led,
=> temporisation in process: blinking led
Comments: the adjustment range of the set point varies between 2° and 40°C*. This maximum temperature may
be decreased in order to protect the swimming pool liner, or it may be increased for specific purposes.
* the temperature is adjusted to the nearest °C assymetrically.
In order to change this maximum set point, access the menu "parameters" and change the parameter
"r2":
1) turn the regulator switch off, the "on" light goes off and the water temperature of the pool is
displayed,
2) press the and
3) press the key to re-enter the number 80, the access code for the menu "parameters", using
the or keys,
4) press the key to validate this code; "PA" is displayed,
5) press the and
6) press the key to view each parameter until "r2" is displayed,
Note: in order to display the parameter value "r2", press the key
Important!
Press the
7) press the and

5.2 Setting of the temperature

The temperature is set by means of the sensitive keys (2)
Display the value of the required temperature by pushing either
Remark: keeping one of these two buttons pressed makes it possible to go into fast search for the desired water
temperature value.
Phase Neutral
Earth
For the power cabl's cross section,
see table
keys simultaneously for five seconds until "PA" is displayed,
keys simultaneously for five seconds,
key in order to validate this new setting.
keys simultaneously to return to the pool water temperature display screen.
Three-phase power supply connection
Heater terminal
Protection with 30 mA differential
strip circuit breaker at line head
Filtration
electric box
Three-phase power supply: 400Vac (R-S-T terminals) + Neutral (N
terminal) + Earth
, then to change it, press
or
5
Phases Neutral
Earth
For the power cabl's cross section,
see table
1
2
the or
key.
GB
5
4
3
key.