Fluval 405 Gebrauchsanleitung Seite 12

INSTALLATION AND USE
9. Insert the AquaStop valve into the intake and output
connectors on the cover, and push down on the silver
lever to lock it in place.
10. Open the AquaStop valve by pushing the black lever, all
the way down. (The valves must be fully open before the
unit is turned on or primed.)
6. Start the filter
1. Check your installation.
a. Be sure lift-lock clamps are securely closed.
b.Make certain that the AquaStop valve is fully open
(with the black lever all the way down.)
c. Check to see that the intake assembly and output nozzle
are both fully submersed in water.
2. Pump the instant-prime handle by pulling it up and pushing
it down vigorously, several times, until you hear water being
drawn into the unit. Return the Instant Prime handle to the
down position. As water flows through the intake hosing, it
will fill the canister, pushing air out of its way. Air will be
expelled through the output nozzle, causing the water in
the aquarium to bubble. To expel all the air in the system as
quickly possible, the AquaStop valve must be fully open: be
sure the black lever is all the way down.
EN-12 EN-12
c
c
b
a