Fluval 405 Gebrauchsanleitung Seite 10

INSTALLATION AND USE
3. Push the cut end of this "output" hosing into the rubber
connector at the top of the output nozzle assembly. Push
the hosing in by at least 1 in. (2.5cm) without twisting it.
4. Place the output nozzle in the tank about 3 in. (7.5 cm)
below the water line; then push the top half of the rim
connector assembly down until it "clicks" to lock the hosing
in place.
5. Prepare the Filter
IMPORTANT: The Carbon and BioMax media supplied with your Fluval filter have been
deliberately placed in Upper, Mid, and Lower level baskets to indicate their recommended
placement for optimal basic filtration. Be sure to note this positioning and place media in baskets
at the same levels as you prepare the filter for use.
1. Remove the foam screen frame, media cover, and media
baskets from the filter canister. As you remove Carbon and
BioMax from baskets, note which levels they were packed in.
Then remove their outer wrappers; do not remove carbon from
porous bag(s).
2. Rinse baskets and media materials under running tap
water to remove any dust, and place media in baskets. Or,
if you prefer, select other media of your own choosing.
(See "Fluval Advanced Filtration" for
more information.)
3. Place rinsed and filled media baskets back in canister, and
put the media cover back on top basket.
IMPORTANT: Make certain that each kind of media is
positioned at the same level it was packaged in, unless you
are deliberately choosing a different filtration plan than the
recommended basic setup. Never overfill baskets. If baskets or
cover are out of position, cover may not close properly.
EN-10 EN-10
"click
to lock"