Technical Data - Resol VBus /PWM Montageanleitung

VBus /PWM interface adapter
®
Overview
VBus /PWM interface adapter
®
The VBus /PWM interface adapter is used for the speed
®
control of a pump via a PWM or 0-10 V signal. Via the VBus
the adapter receives information from the controller about
speed. The speed is converted into a PWM or direct voltage
signal and put out to the corresponding terminals.
A signal corresponding to the speed is only available if the
corresponding relay is designed for pump speed control.
Otherwise, a signal – depending on the position of the relay
– for the on or off state is transmitted.
The VBus /PWM interface adapter is designed for the con-
®
nection to the following devices:

Technical data

Housing: plastic
Protection type: IP 20 (EN 60529)
Ambient temperature: 0 ... 70 °C
Dimensions: 95 × 70 × 25 mm
Mounting: Wall mounting is possible
(but not required)
Display: 7-segment LED display
Power supply:
Mains power supply:
220 ... 240 V~ / 50-60 Hz
Adapter: power supply:
12 VDC, 0.5 A
5.5 x 2.5 mm
Interface: RESOL VBus
®
• Speed control of high-efficiency pumps for
controllers without integrated PWM outputs
• Easy to install
• Convertible from PWM to 0-10 V signal
• With 7-segment LED display
• • D e lt a S o l AL
®
®
• • D e lt a S o l BS
®
• • D e lt a S o l BS Plus
®
• • D e lt a S o l
C
®
• • D e lt a S o l D
®
• • D e lt a S o l DB
®
• • D e lt a S o l E
®
• • D e lt a S o l ES
®
• • D e lt a S o l
M
®
• • D e lt a S o l MiniPool
®
• • D e lt a S o l
Pool
®
• • D e lt a S o l Sensor
®
• Midi Pro
• Diemasol C
• DrainBloC
Included:
1 × mains adapter 12 V / 0.5 A / 5.5 x 2.5 mm
1 × VBus cable 1.5 m
®
1 × accessory bag containing
2 × screw and wall plug
4 × self-adhesive, skid-proof rubber pad
• DT4 (B)
• DT4 (MS)
• DT5
• Frista
• Friwa
• Multitronic
• REGLOfresh / Felix
• S2
• S3
• SKSC1
• SKSC2
• SKSC3
• SLR
• SOLEX
• Vitosolic 200
B
5.5 x 2.5 mm
11
|