Power Connector; Control Button; Led Indicators - Axis Q1942-E Bedienungsanleitung

AXIS Q1942-E Thermal Network Camera
Hardware Overview
• Input/Output (I/O) devices
When connecting external equipment, an Axis multicable is required in order to maintain the product's IP rating. For more
information, see Axis multicable on page 56.

Power Connector

Terminal connector for connecting AC/DC power supply.
SD card slot
NOTICE NO NO TICE TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when inserting or removing the
SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product is running. Disconnect power or
unmount the SD card from the Axis product's webpages before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com

Control Button

For location of the control button, see Hardware Overview on page 7 .
The control button is used for:
• Resetting the product to factory default settings. See page 55.
• Connecting to an AXIS Video Hosting System service. See page 47. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 47. To connect, press and hold the button for about 3 seconds.

LED Indicators

Status LED
Unlit
Green
Amber
Amber/Red
Red
Indication
Connection and normal operation.
Connection and normal operation.
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
8