Axis Q1942-E Bedienungsanleitung Seite 60

AXIS Q1942-E Thermal Network Camera
Troubleshooting
Distorted audio
Feedback loops
Storage and disk management problems
Storage disruption
Video cannot be recorded
SD card cannot be mounted
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Feedback loops might appear in full-duplex mode. Try moving the microphone or the speaker, or
use half-duplex mode instead.
A storage disruption alarm is sent if a storage device is unavailable, removed, full, locked or if other
read or write problems occur. To identify the source of the problem, check the System Log under
System Options > Support > Logs & Reports. Depending on the problem, it might be necessary to
re-mount the storage device.
For information on how to set up a storage disruption alarm, see Events on page 35.
Check that the SD card is not write protected (that is, read only).
Reformat the SD card and then click Mount.
NOTICE TICE
NO NO TICE
Formatting the card will remove all content, including all recordings, from the SD card.
60