Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 VU meter AF (audio frequency) for the audio
signal received
2 Receiving antennas A and B
3 Display to indicate
1. the channel group (GROUP 00 – 09)
2. the channel (CHANNEL 00 – 99)
3. the line output level adjusted (VOL 00 – 63)
for the jack LINE OUT (12)
4. the RF signal strength (
5. which of the two receiving parts of the unit
receives the most powerful radio signal; indi-
cation via the antenna symbol
on the right
4 Button SET: To change the channel group, the
channel number or the line output level, press
the button SET repeatedly until the correspond -
ing numerals start flashing on the display (3).
While the numerals keep flashing, make the set-
tings with the buttons
5 Buttons
and
channel number and the line output level
6 IR window for the IR signals to set the channel
of the wireless microphone / pocket transmitter
7 Button ACT
1. For sending IR signals to adjust the channel
of the wireless microphone / pocket transmit-
ter, briefly press the button.
2. For automatic search of a free receiving
channel, press the button until the outer dis-
play elements of the numerals for GROUP
and CHANNEL start moving clockwise on the
display.
8 POWER switch
1. To switch on, press the button until the dis-
play lights up.
2. To switch off, press the button until the display
shows OFF.
9 Power supply jack to connect the power supply
unit provided
8
)
on the left or
and
(5).
to set the channel group, the
10 XLR audio output for connection to a micro-
phone input
11 Control SQUELCH to adjust the threshold for
interference suppression
12 Audio output (6.3 mm jack) for connection to a
line input
13 Antenna jacks
2 Safety Notes
The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage. Leave servicing
to skilled personnel only. Inexpert
handling of the unit may result in
electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity and heat (admissible ambient
temperature range 0 – 40 °C).
G
Do not operate the receiver and immediately dis-
connect the power supply unit from the socket
1. if the receiver or the power supply unit is visi-
bly damaged,
2. if a defect might have occurred after a unit was
dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the units must be repaired by skilled
personnel.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they
are not correctly connected or operated, or if they
are not repaired in an expert way.
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful to
the environment.
.
Werbung
Inhaltsverzeichnis
