Ordering Information; Maintenance, Repair And Cleaning - Siemens 7KE6000-8AK/DD Betriebsanleitung

Sync-Transceiver

Ordering Information

Item
Sync-Transceiver
Power supply

Maintenance, Repair and Cleaning

The Sync-Transceiver 7KE6000-8AK/L do not require special maintenance. If necessary,
they can be checked in a laboratory.
Repair of defective modules is never recommended because specially selected electronic
components are used which must be handled in accordance with the procedures required
by Electrostatically Endangered Components (EEC).
Therefore, if a device defect is suspected, it is recommended that the complete device be
returned to the manufacturer. Use the original transport packaging or an appropriate
packaging for return.
If it is unavoidable to replace individual modules, it is imperative that the standards related
to the handling of Electrostatically Endangered Components are observed.
The meter should be mounted in a dry, dirt free location. Once installed, it is not necessary
to clean the device. To operate properly and effectively, environmental conditions should fall
within the guidelines listed in the Technical Data, page 33.
If necessary, the device can be switched off and wiped with a clean, dry and soft cloth. Do
not use solvents.
E50417-K1074-C294-A2
Order number
7KE 6
DC 24 V to DC 60 V
DC 110 V to DC 250 V
AC 100 V to AC 230 V; 45 Hz to 65 Hz
Warning
When carrying out changes on site, the instructions for handling electro-
statically endangered components must be observed (EEC).
0 0 0 – 8 A
Short form
¦
K
L
English
37