Initial Operation; Setting Up The Device; Connecting Power Supply; Charging The Battery - Philips PicoPix PPX5110 Bedienungsanleitung

3 Initial operation

Setting up the device

Place the projector on a flat surface in front of
the projection surface.

Connecting power supply

CAUTION!
Always use the
off the projector.
1 Slide the appropriate plug (EU, UK, US) onto
the power adapter.
US
EU
2 Connect one end of the power cable to the
DC IN socket on the rear side of your device
(1).
3 Plug the power cable to outlet in the wall (2).
a

Charging the battery

The projector is built with an embedded battery
for mobile use. The battery will be charged only
when the device is not in use (Power off).
Before using the first time, charge the projector
for five hours.
The blue charging LED blinks during charging. If
the projector is fully charged the LED stops
blinking.
Initial operation
B button to turn on and
UK
b
DANGER!
Risk of explosion with incorrect type of
batteries!
Do not try to replace the battery your-
self.

Initial installation

Turning on the projector
1 To turn on (and off) the device, press the
B button for eight seconds till the initial
screen appears.
2 Turn the projector towards a suitable projec-
tion surface or wall. Note that the distance to
the projection surface must be a minimum of
0.5 metres and a maximum of approx.
3 metres. Make sure the projector is in a
secure position.
The distance between the projector and the
screen determines the actual size of the
image.
3 Use the focus wheel on the left side to adjust
the image sharpness.
7