Hauck Run Uno Zero Go Gebrauchsanweisung Seite 7

ASSEMBLY INSTRUCTIONS AND INSTRUCTIONS FOR USE
1. ERECTING (fig 1)
Release transport lock.
2. UNFOLDING (fig. 2)
Tip forward to open the stroller, and press down both cross bars at the back of the stroller until
they are securely engaged.
3. FRONT WHEEL ASSEMBLY (fig. 3)
Push both front wheels into position. Make sure the pushpin locks in place and cannot be pull
off. When changing the wheel, reverse the sequence.
4. FRONT WHEEL ADJUSTMENT (fig 4)
Slide the front wheel lever up to lock the swivel movement. To release the swivel movement,
slide the lever down.
5. TWIN BRAKE FOR REAR WHEELS (fig. 5)
Press both brakes down to stop the rear wheels and push the stroller to check.
Attention: Always apply both brakes when parking the stroller.
6. FOLDING AWAY (fig. 6)
a. Lift up the primary safety lock with your foot;
b. Lift up the top safety lock and push the handle forward to close the stroller; Secure the stroller
with the transport lock
7. SECURE THE CHILD IN THE SEAT (fig 7)
Place the child in the seat, secure by fixing the waist belt & crotch belt together. Adjust the
length of the belt to your child's needs. To release the harness, squeeze & open the buckle.
WARNING: (A child's safety is your responsibility.) The child should be harnessed in at all times
and should never be left unattended. The child should be clear of moving parts while making
adjustments. This stroller requires regular maintenance by the user.
Attention: Avoid serious injury from failing and sliding out, always use seat belt & always use as
instructed.
CARE AND MAINTENANCE
GENERALLY
Please check your pushchair's functions regularly. Make sure that the frame is stable, the screws
sit firmly, the interlocking devices close securely, the wheels are retained securely and the brakes
are in working order. Check from time to time that the seams in the textile upholstery are strong and
that the plastic parts are in good condition. Defective or worn parts should always be exchanged
immediately. Proceed likewise with components which are broken, torn, defective or worn. Please
use only hauck's original spare parts while doing so. Do not place your pushchair in strong sunlight
because it could fade the textile covers and plastic parts
CLEANING THE COVERS
Remove the cover from the frame by loosening the straps, push-button catches or screws. Please
follow the advice given on the sewn-in washing label before washing the cover. Only use a damp
cloth to wipe off the cover, in order to conserve it properly. Please make sure that you do not soak
the entire cover, whenever you clean textile covers that are filled with irremovable padding. You can
wash the cover in a washing machine at 30°C and then spin-dry it at an average spinning speed, if
you do not find any parts made of plastic, wood or metal in the cover. Allow the cover to dry in the
open air but not in direct sunlight. Please avoid shrinkage by not putting the cover into a tumble drier.
Only refit the covers after they have dried out completely.
CLEANING THE FRAME
Dry off the pushchair with a soft cloth after cleaning it, or after it has been used in rain or snow. Only
use mild soapsuds or lukewarm water, in order to clean your pushchair's frame. Plastic parts can be
cleaned with commercially available cleaning agents.
MAINTAINING THE WHEELS
Clean and maintain the wheels regularly. Treatment with a silicon spray or an anti-corrosive spray
protects them from rust and soiling. You must ensure during the winter that residues of scattered salt
and sand are removed immediately. Remove dirt from the wheels and axles regularly.
GB
7