Aukey PM-YY Bedienungsanleitung Seite 5

1. Connect the mini-B connector of this hardwire kit to your AUKEY or other dash
camera, and connect the OBD-II DLC port adapter to the OBD-II DLC port of
your car's fuse box (see notes below)
2. Use the 3M adhesive pad to stick the motion detection sensor to the windshield
in a position similar to that shown in the above diagram
3. Arrange the cable conveniently and safely so it won't distract you or dangle
in the way of the car foot pedals or door. Careful placement of the cable
and use of existing trim to conceal it will give a tidier finish
Notes
● It is advisable to connect and test the hardwire kit to ensure it operates
correctly and supplies power to your dash camera before fixing the motion
sensor and tidying up the cable
● All cars sold within the U.S. from 1996 (European courtries from 2000) onward
have the OBD-II (On-Board Diagnostics II) 16-pin DLC (Data Link Connector)
port. It will be located under the dash within two feet of the steering wheel,
usually just underneath the steering column or near the fuse panel
- 03 -