Commissioning And Maintenance; Releasing The Transducer; Dimensional Drawing; Application Notes - Camille Bauer SINEAX G536 Betriebsanleitung

6. Commissioning and maintenance

Switch on the power supply and the measuring input. It is
possible during the operation to disconnect the output line
and to connect a check instrument, e.g. for a functional test.
No maintenance is required.

7. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 6.
Fig. 6

9. Application notes

Current connection in
phase:
Voltage connection
between:
Vector diagrams
Current connection in
phase:
Voltage connection
between:
Vector diagrams

10. Instruments admissions

Germanischer Lloyd
Type approval certifi cate:
12 261-98 HH
CSA approved for USA and Canada
fi le-nr. 204767
14
L1 L2
L1 & L2 L2 & L3
L1 L1 L1 L1
L3 L3 L2 L2 L3
L3 L1
L1 & L2 L2 & L3
L1 L1 L1 L1
L3 L3 L2 L2 L3

8. Dimensional drawing

112.5
114.1
Fig. 7. Housing P13/70 clipped onto a top hat rail (35 ×15 mm or
35×7.5 mm, acc. to EN 50 022).
L3
L3 & L1 L1 & L3
L1 L1
L3
L2 L2 L3 L2 L2
L2
L3 & L1
L1 L1
L2 L3 L2 L2
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to both part 15 of the FCC Rules
and the radio interference regulations of the Canadian Department
of Communications: These limits are designed to provide reasona-
ble protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is like to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
10 11
1 2
L1 L2
L2 & L1
L1 L1
L1 L1
L2 L2
L3 L2 L2
L
L & N
I U
12 13
3 4 5 6 7 8 9
70
L3
L3 & L2
L1 L1
L3 L2 L2