Commissioning; Pmi O315 Atex; Pmi V315 Atex; Activating Setup - Pilz PMI v315 ATEX Bedienungsanleitung

Commissioning

WARNING!
Before commissioning, bring the operator terminal in line with room
temperature. Where condensation occurs, do not switch on the operator
terminal until it is absolutely dry.
Procedure after power-up
There may be a delay of several seconds between power-up and the unit
being ready for operation.

PMI o315 ATEX

Software
No other user software apart from the operating system (Windows CE.NET 4.2)
is installed when the unit is delivered.
It is up to the customer to install the user software and start it appropriately.
The installation of the following software has been tested:
• zenOn from COPA-DATA
• Web Studio from InduSoft
• Movicon from Progea

PMI v315 ATEX

Activating setup

If you do not press the SETUP button within 2 seconds, the
"PMIStart.cmd" script file will be run. "PMIStart.cmd" is a batch file which is
processed step by step.
INFORMATION
The "PMIStart.cmd" script file must contain the PMI-PRO runtime and the
transport service.
Fig. 6-1: Activating setup
Operating Manual: PMI v315 ATEX/PMI o315 ATEX
6-1