Pitco frialator AE14S Bedienungsanleitung Seite 2

THE OIL LEVEL SHOULD NOT FALL BELOW THE MINIMUM INDICATED LEVEL AT ANY
INSTALLATION AND ALL CONNECTIONS MUST BE MADE ACCORDING TO NATIONAL
AND LOCAL REGULATIONS AND CODES IN FORCE.
THE FRYER IS NOT JET STREAM APPROVED. DO NOT CLEAN THE APPLIANCE WITH
INSTALLATION SHOULD ONLY BE DONE BY A COMPETENT SERVICE TECHNICIAN.
THE MODEL & SERIAL NUMBER, AND ELECTRICAL REQUIREMENTS STAMPED INTO
THE DATA PLATE, LOCATED ON THE INSIDE PANEL OF THE DOOR.
THIS APPLIANCE IS INTENDED FOR PROFESSIONAL USE ONLY, AND AS SUCH,
SHOULD BE OPERATED BY FULLY TRAINED PERSONNEL.
IT IS RECOMMENDED THAT THIS MACHINE BE INSPECTED BY A QUALIFIED TECHNI-
THE POWER SUPPLY MUST BE DISCONNECTED SERVICING OR CLEANING THE UNIT.
SHORTENING, WHEN IT IS AT OPERATING TEMPERATURES, IS VERY HOT AND
DANGEROUS! USE EXTREME CAUTION WHEN HANDLING! USE PROPER PROTEC-
TIVE GEAR SUCH AS INSULATED GLOVES, APRONS, FACE SHIELD, AND SLEEVES
WHEN HANDLING HOT SHORTENING. DO NOT ATTEMP TO MOVE MACHINE THAT
HAS HOT OIL IN IT. ALLOW TO COOLTO ROOM TEMPERATURE OR DRAIN THE OIL
INTO A SUITABLE
L20-227 Rev. 1 9/2001
WARNING! FIRE HAZARD
TIME.
WARNING
WARNING
A WATER JET.
NOTICE
NOTICE
NOTICE
CIAN ON A YEARLY BASIS.
WARNING
WARNING
CONTAINER BEFORE MOVING THE FRYER.