Replacing The Fuse; Cleaning And Maintenance - Omnitronic PEQ-131 Bedienungsanleitung

difficulty, simply push this Range Selector Switch. The L.E.D. (5) will change from red to green, indicating
that the maximum boost/cut range of the frequency sliders has been reduced from 12 dB to 6 dB.
Now you can make your adjustments taking advantage of the greater fader travel necessary to get the same
amount of hoost or cut.
4) EQ OUT/IN SWITCH WITH L.E.D. This switch allows instant comparison of the original sound with the
equalized sound. The L.E.D. will turn off where the Equalizer is out of the circuit.
5) HIGH CUT – Filters the highs.
Rearpanel:
(6) AC VOLTAGE-SELECTOR
Make sure that the selector is properly set.
(7) FUSEHOLDER
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same rating and
power.
(8) AC-CONNECTION
Used to plug the power-cord in.
(9) OUTPUT-SOCKET
(10) INPUT-SOCKET

REPLACING THE FUSE

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating (F 0,315 A, 250 V fast).
Please note: This fuse is being used for both 115 V and 230 V.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free cloth moistened with any good
cleaning fluid. Never use alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
16