Preparation Before Use; Battery Connecting - WFT Electra 1200 PRHP - Mission Red Handbuch

PREPARATION BEFORE USE

Battery Connecting

(Fig. 1) Connect the red clip of the cable to the
positive (+) and the black clip to the negative (-)
terminal of the battery..
(Fig. 2) Connect the cable plug to the power cable
port on the reel body. Then fasten the screw ring
finger-tight.
(Fig. 3) When the battery is connected correctly before the first
line-data input, the LCD displays the message shown in Fig. 3.
(Fig. 4) If there is already line data stored the LCD will display
the message shown in Fig. 4.
* Fig. 4: Battery charge indicator flashes: This message will dis-
appear within 5 minutes when there is sufficient charge in the
battery. If the message does not disappear the battery needs
to be replaced or re-charged.
If you have already saved a 'Bait-at-Hand' or 'Water-Surface-
Zero' stop position for safety reasons, a motorized line retrieve is only possible when the released line length
exceeds the saved stop position.
!
Attention
28
* Data such as the 'Bait-at-Hand' position, the 'Water-Surface-Zero' position and the target depth are stored in
the microprocessor's memory for 10 minutes after disconnection of the battery. This data must be re-entered
and saved if the reel has been disconnected from the power supply for more than 10 minutes.
(1)
(3)
(2)
(4)
blinkt