Herunterladen Inhalt Inhalt Diese Seite drucken

Declaration Of Conformity - Hameg Instruments HM 7042-4 Handbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Hersteller
HAMEG GmbH
Manufacturer
Industriestraße 6
Fabricant
D-63533 Mainhausen
Die HAMEG GmbH bescheinigt die Konformität für das Produkt
The HAMEG GmbH herewith declares conformity of the product
HAMEG GmbH déclare la conformite du produit
Bezeichnung / Product name / Designation:
Dreifach
Netzgerät/Tripple Power Supply/
Alimentation triple
HM 7042-4
Typ / Type / Type:
mit / with / avec: -
Optionen / Options / Options:
mit den folgenden Bestimmungen / with applicable regulations / avec les
directives suivantes
EMV Richtlinie 89/336/EWG ergänzt durch 91/263/EWG, 92/31/EWG
EMC Directive 89/336/EEC amended by 91/263/EWG, 92/31/EEC
Directive EMC 89/336/CEE amendée par 91/263/EWG, 92/31/CEE
Niederspannungsrichtlinie 73/23/EWG ergänzt durch 93/68/EWG
Low-Voltage Equipment Directive 73/23/EEC amended by 93/68/EEC
Directive des equipements basse tension 73/23/CEE amendée par 93/68/CEE
General remarks regarding the CE marking
HAMEG measuring instruments comply with the EMI norms. Our tests for conformity are based upon the relevant norms.
Whenever different maximum limits are optional HAMEG will select the most stringent ones. As regards emissions class 1B
limits for small business will be applied. As regards susceptability the limits for industrial environments will be applied.
All connecting cables will influence emissions as well as susceptability considerably. The cables used will differ substantially
depending on the application. During practical operation the following guidelines should be absolutely observed in order to
minimize EMI:
1. Data connections
Measuring instruments may only be connected to external associated equipment (printers, computers etc.) by using well
shielded cables. Unless shorter lengths are prescribed a maximum length of 3 m must not be exceeded for all data
interconnections (input, output, signals, control). In case an instrument interface would allow connecting several cables only
one may be connected.
In general, data connections should be made using double-shielded cables. For IEEE bus connections the double-shielded
HAMEG cables HZ72S and HZ72L are suitable.
2. Signal connections
In general, all connections between a measuring instrument and the device under test should be made as short as possible.
Unless a shorter length is prescribed a maximum length of 3 m must not be exceeded, also, such connections must not leave
the premises.
All signal connections must be shielded (e.g. coax such as RG58/U). With signal generators double-shielded cables are
mandatory. It is especially important to establish good ground connections.
3. External influences
In the vicinity of strong magnetic or/and electric fields even a careful measuring set-up may not be sufficient to guard against
the intrusion of undesired signals. This will not cause destruction or malfunction of HAMEG instruments, however, small
deviations from the guranteed specifications may occur under such conditions.
14
KONFORMITÄTSERKLÄRUNG

DECLARATION OF CONFORMITY

DECLARATION DE CONFORMITE
Angewendete harmonisierte Normen / Harmonized standards applied / Normes
harmonisées utilisées
Sicherheit / Safety / Sécurité
EN 61010-1: 1993 / IEC (CEI) 1010-1: 1990 A 1: 1992 / VDE 0411: 1994
Überspannungskategorie / Overvoltage category / Catégorie de surtension: II
Verschmutzungsgrad / Degree of pollution / Degré de pollution: 2
Elektromagnetische Verträglichkeit / Electromagnetic compatibility / Compatibilité
électromagnétique
EN 61326-1/A1
Störaussendung / Radiation / Emission: Tabelle / table / tableau 4, Klasse / Class /
Classe B.
Störfestigkeit / Immunity / Imunitee: Tabelle / table / tableau A1.
EN 61000-3-2/A14
Oberschwingungsströme / Harmonic current emissions / Émissions de courant
harmonique: Klasse / Class / Classe D.
EN 61000-3-3
Spannungsschwankungen u. Flicker / Voltage fluctuations and flicker / Fluctuations
de tension et du flicker.
Datum / Date / Date
14.01.2004
Instruments
Unterschrift / Signature / Signatur
G. Hübenett
Product Manager
HAMEG GmbH
Subject to change without notice
®

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis