Velleman DB6 Bedienungsanleitung Seite 6

8. Adding or Replacing Push Buttons
You can use up to 4 push buttons with the same chime unit. If you
want to use a new push button, you need to make sure that the
chime unit recognises the code of the new push button. Proceed as
follows:
1. Install the battery in the push button.
2. Press the coding button [1] on the chime unit.
3. Press the push button.
If the code is set correctly, the chime unit will produce a chime.
4. You can now install the push button in its desired location.
9. Troubleshooting
• When the sound becomes weak, replace the batteries of the chime
unit (see §6).
• If pushing the push button does not produce a chime:
o Check if the chime unit is located within the specified range
(max. 60 m in open field). If not, bring it closer to the push
button.
o Check if chime unit and doorbell push button are not
surrounded by metal or near a strong magnetic field. In these
cases, move the chime unit and/or doorbell push button to a
more suitable location.
o Replace the push button battery (see §6).
o Create a new code between chime unit and push button
(see §8).
10. Technical Specifications
chime unit
transmission frequency
range
power supply
push button (transmitter)
chime unit (receiver)
push button protection grade
dimensions
push button (transmitter)
chime unit (receiver)
transmitting power
V. 01 – 17/10/2012
DB6
free standing or hanging
433.92 MHz
max. 60 m (in open field)
1 x 3 V battery (type CR2032C)
3 x AA battery 1.5 V (LR6C, not incl.)
IP44
32 x 80 x 18 mm
96 x 140 x 37 mm
<= 10 mW
6 ©Velleman nv