Velleman DB6 Bedienungsanleitung Seite 5

Doorbell Push Button
1. Open the doorbell push button by pushing gently with a small
screwdriver in the notch at the bottom of the casing [8] and
removing the cover.
2. Insert a lithium CR2032 battery (incl.) according to the polarity
markings [9].
3. To place the cover back, first align the top of the cover [7], then
push the bottom [8] until it snaps into place.
Note: If you align the bottom first, the cover will not close
correctly and it may come loose.
7. Installation
The doorbell push button contains a transmitter, that sends a code to
the receiver located in the chime unit. Before installing the push
buttons, you have to make sure that the chime unit recognises the
code of the push button. Proceed as follows:
1. Make sure that batteries are installed in chime unit and doorbell
push button.
2. Press the push button. The chime unit automatically recognises
the code and produces a chime.
3. Press the chime selection button [2] repeatedly to select the
desired melody.
4. Press the volume button [3] repeatedly to select the desired
volume level.
5. Place the chime unit and push button in their desired locations.
Note: Do not fix the units in place yet.
You can hang the chime unit from a wall, or you can extend the
foot [4] and stand the unit upright on any surface.
6. With chime unit and push button in position, test the connection
by pressing the push button. If the connection is OK, the chime
unit produces a chime. (If there is no chime, see §9 for
troubleshooting information.)
7. Fix the doorbell push button in the desired location using
double-sided tape at the back [10].
V. 01 – 17/10/2012
DB6
5 ©Velleman nv