HP DesignJet ColorPro CAD Inbetriebnahmeanweisungen Seite 28

Anhang - Wichtige Hinweise und Bestimmungen
FCC Regulations
CAUTION
The U.S. Federal Communications Commission (in 47 cfr 15.105)
has specified that the following notices be brought to the attention
of users of this product.
Product Identification Numbers:
HP DesignJet ColorPro CAD HP DesignJet ColorPro GA
Printer
Model C7777A
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Shielded cables
Use of a shielded data cables is required to comply with the Class
B limits of Part 15 of the FCC Rules.
Pursuant to Part 15.21 of the FCC Rules, any changes or
modifications to this equipment not expressly approved by the
Hewlett-Packard Company, may cause harmful interference
and void the FCC authorization to operate this equipment.
This equipment has been tested and found to comply with the
specifications of Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can
radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate receiving antenna.
+3 'HVLJQ-HW &RORU3UR 6HULHV /HLWIDGHQ ]XU ,QEHWULHEQDKPH $QKDQJ  
$QKDQJ  :LFKWLJH +LQZHLVH XQG %HVWLPPXQJHQ
C7778A