Exhaust Air Filter - Mitsubishi Electric VL-50SR2-E Bedienungsanleitung

(4) Remove the outside air filter.
Hold the knob of the outside air filter to pull it
out.
Outside air filter
(5) Remove the Lossnay Core.
Press the prong of the Lossnay Core's handle
and pull the handle toward you to remove the
core.
Lossnay Core
Cleaning
(1) Outside air filter
1 Press the tab at two locations to open the filter
frame.
2 Remove the outside air filter.
Outside air filter
Press
3 Vacuum the dust from the filter, and then
handwash it in water with a neutral detergent
or in lukewarm water (up to 40°C). Then dry it
thoroughly to remove moisture.
Vacuum cleaner
Outside air filter
2
Tab
1
Filter frame
Replacement:
Replace the filter with separately sold parts
(P-50F -E) when it has been washed four times.
2

(2) Exhaust air filter

1) Open the exhaust air filter as shown in the
figure.
2) Either lightly tap with your hand or remove
dust with a vacuum cleaner.
3) If it is excessively dirty, wipe with a cloth
soaked in water and tightly wrung out.
Open the
filter frame
Note
- Never wash with hot water or do rubbing
wash.
- Do not dry the filter by directly holding it up
to an open flame.
- If a separately available high performance
dust filter is used, clean the filter in
accordance with the instructions in its
Instruction Manual.
(3) Lossnay Core
Use a vacuum cleaner to remove surface dust.
- Vacuum the surface gently with the vacuum
cleaner nozzle.
Lossnay Core
Note
- Do not expose the Lossnay Core to water,
chemicals, or volatile solutions.
- Do not wash Lossnay Core with water.
- Do not expose the Lossnay Core close to
open flames.
- Do not press wires, screwdrivers or hard
vacuum cleaner nozzles into the surface.
Eng-10
Push sideways to
remove the tab
Vacuum
cleaner
Exhaust air
filter
Vacuum cleaner