Environmental Protection And Disposal; Introduction; Material Categories; Contact Addresses - Heiniger Icon Bedienungsanleitung

• Making sure at all times that you have a cutting tension on the cutter, adjust the centre post
up or down until the second ledge sits on the front of the machine surface around the oil
hole.
• Lock the centre post lock nut and recheck making sure that both ledges remain seated.
Illustr. 17, 18
• When correctly set it will be as per Illustration 18.

6 Environmental Protection and Disposal

6.1 Introduction

The owner has a duty to dispose of the shearing blades as well as of the shearing handpiece
properly at the end of its service life. Please observe your relevant national regulations.

6.2 Material Categories

Shearing blades and the whole shearing handpiece consist of high alloy steel and can be
disposed at scrapping facilities.

7 Contact Addresses

Your purchasing point or the company shown on your guarantee certificate are authorised
service centres or refer to the nearest service centre in your area.
Instruction manual ICON 19